PRO-POINT 8306052 Manuel D'utilisation page 11

V1.0 1/2 IN. DR MAINTENANCE FREE AIR IMPACT WRENCH
AIR TOOL LUBRICATION
NOTICE! Only use air tool oil to lubricate the tool. Other
lubricants are not suitable and will damage the tool or cause
a malfunction during use.
NOTICE! Never use a penetrating oil to lubricate an air tool.
Penetrating oil acts as a solvent that will dissolve the tool's
grease packing and may damage the o-rings, causing the tool
to seize or malfunction.
1. All air tools have an internal coating of grease to prevent
corrosion during shipping and storage. Remove this
grease by adding a generous amount of air tool oil in the
air inlet and then run the tool under no load until the
exhaust is clear.
2. The maintenance-free design of this tool means that the
daily addition of air tool oil is not required. However, for
optimum performance, you should add 1 or 2 drops of air
tool to the air inlet every 3 months.
3. Avoid adding too much air tool oil as this can cause premature
power loss and eventual tool failure. A qualified technician will
need to take the tool apart and clean out the excess oil.
STORAGE
When not in use for an extended period, apply a thin coat of
lubricant to the steel parts to avoid rust. Remove the lubricant
before using the tool again.
DISPOSAL
Recycle a tool damaged beyond repair at the appropriate facility.
Contact your local municipality for a list of disposal facilities or
by-laws for electronic devices, batteries, oil or other toxic liquids.
IMPORTANT! DO NOT pollute the environment by allowing
uncontrolled discharge of waste oil.
Visit www.princessauto.com for more information
8306052
11