Locking And Unlocking Your Safe; Bolt Down Instructions - Sentrysafe Qap1E Manuel Du Propriétaire

Locking And Unlocking Your Safe

Locking your safe
1
Close the lid. Once the lid is closed, the safe is securely locked.
2
To optimize security please be sure to always lock your safe.
NOTE: When not in use – the safe will go into standby mode. This is a lower power mode.
Pressing a key will end the standby mode.
Unlocking your safe
1
Press any button once to bring the safe out of
A
standby mode.
Put in your code.
B
–OR–
2
Use the override key to gain access to your safe.
6

Bolt Down Instructions

Bolting down your safe
Bolt down kit contents:
2 Anchors
2 Lag screws
2 Washers
Tools needed to bolt safe to a surface:
Drill
Wrench
9/32" (7.2 mm) drill bit – for drilling into wood
3/8" (9.5 mm) drill bit – for drilling into masonry
1
Select a suitable location for your Quick Access Pistol Safe.
Set the safe in place, and use the predrilled holes provided on
the bottom of the safe to mark the location of the holes to be
drilled in the surface.
WARNING
Do NOT drill from any location inside the safe.
NOTE: This product is intended to be mounted with a horizontal orientation.
2
Move the Quick Access Pistol Safe while you drill the marked
holes in the surface.
7