Cleaning; Storage; Troubleshooting - Parkside Performance Ppwsfa 20-Li B3 Traduction Des Instructions D'origine

You should have any repair and main-
tenance work that is not described in
these instructions carried out by our
Service Centre. Only use original re-
placement parts.

Cleaning

WARNING! Electric shock! Never
spray down the device with water.
NOTICE! Risk of damage. Chemic-
al substances may attack the plastic
parts of the machine. Do not use any
cleaning agents or solvents.
• Keep the ventilation slits, motor
housing and handles of the ma-
chine clean. Use a damp cloth or
brush to do this.
Cleaning the dust protection grille
(Fig. E)
• Clean the dust protection grille (4)
with a brush.
• You can remove the dust protec-
tion grille for thorough cleaning.
To do this, insert a narrow slotted
screwdriver at the marked point.
Replace a defective dust protec-
tion grille (Spare parts and ac-
cessories, p. 55).

Troubleshooting

The following table will assist you in fixing faults:
Problem
Device does not start
Attachment tool does not
move although motor is
running
Maintenance
The device is maintenance free.

Storage

Always store the device and ac-
cessories:
• clean
• dry
• protected against dust
• In the case provided (30)
• out of the reach of children
Devices with battery:
• The storage temperature for the
battery and device is between 0 °C
and 45 °C. Avoid extreme cold
or heat during storage to ensure
the battery output is not adversely
affected.
• Remove the battery from the
device before storage over a longer
period (see separate operating in-
structions for battery and charger).
Storing cutting/grinding discs
• dry
• upright
• unstacked
Possible cause
Rechargeable battery (3)
not inserted
On/Off button (17) defect-
ive
Defective motor
Clamping nut (27) loose
Workpiece, workpiece
remnants or remnants of
attachment tools blocking
the drive
GB
Error correction
Inserting the battery,
p. 48
Contact the service
centre.
Contact the service
centre.
Tightening the clamping
nut
Remove blockages
MT
51