Fitting And Removing The Attachment On The Guard Cover; Checking The Battery Charge Level - Parkside Performance Ppwsfa 20-Li B3 Traduction Des Instructions D'origine

GB MT
Fitting and removing the wire brush
CAUTION! Risk of injury
when touching the attachment
tool. Wear protective gloves
when handling the attachment
tool.
Tools required
• Open-end spanner (not included)
Removing the wire brushes (Fig. D)
1. Press and hold the spindle lock
(10).
2. Turn the uptake spindle (29) until
the stop button holds the uptake
spindle in a fixed position. Keep
pressing the spindle lock (10).
3. Release the wire brush with an
open-end spanner.
You can release the spindle lock
(10).
Fitting the wire brush (Fig. D)
1. Place the desired wire brush onto
the uptake spindle (29).
2. Press and hold the spindle lock
(10).
3. Turn the wire brush onto the up-
take spindle (29). Tighten the
wire brush using a combination
wrench.
You can release the spindle lock
(10).
Fitting and removing the
attachment on the guard
cover
CAUTION! Risk of injury
when touching the attachment
tool. Wear protective gloves
when handling the attachment
tool.
Requirements
• Cutting disc mounted
• Battery removed from device
46
Fitting the attachment (19) (Fig. B)
1. Place the attachment (19) on the
guard cover (6) and turn the at-
tachment (19) until it audibly clicks
into place.
Removing the attachment (19)
(Fig. B)
1. Release one of the two locks (20)
on the attachment (19) by pushing
the lock (20) outwards.
2. Slide the released lock (20) over
the guard cover (6) until the at-
tachment is removed after half a
turn.
Checking the battery
charge level
LEDs
red, orange, green Battery charged
red, orange
red
At the battery
1. Press the button (22) next to the
charge level indicator button (23)
on the battery (3).
The LEDs of the charge level in-
dicator show how much charge re-
mains in the battery.
2. Charge the battery (3) when only
the red LED on the charge level in-
dicator (23) is illuminated.
At the tool
1. The charge level indicator (13)
lights up during operation. If the
charge level indicator does not
light up, press the Unlock button
(15).
The LEDs of the charge level in-
dicator show how much charge re-
mains in the battery.
Meaning
Battery partially
charged
Battery needs to
be charged