Inserting And Removing The Battery - Parkside Performance Ppwsfa 20-Li B3 Traduction Des Instructions D'origine

GB MT
procedure as well as after every
tool change. Switch the tool off im-
mediately if the tool is not rotat-
ing smoothly, if considerable vibra-
tion occurs, or if you hear abnormal
noises.
Abrasive cutting
Requirements
• Cutting disc
NOTICE! Property damage. Never
use a roughing disc for cutting!
• diameter ≤125 mm
• Thickness ≤1.2 mm
• Cutting disk types: diamond
studded, bonded reinforced,
segmented
• Attachment (19) mounted on guard
cover (6)
Notes
• In general, work with a low feed
rate. Exert only moderate pressure
on the work-piece.
Information on building statics
Slits in structural walls are subject
to the country-specific regulations.
These regulations must be observed
without fail.
Before beginning work you should
ask the structural engineer, architect
or relevant construction supervisor for
advice.
Roughing
Requirements
• Roughing wheel
NOTICE! Property damage. Never
use a cutting disc for roughing!
• diameter ≤125 mm
• Thickness ≤6 mm
• Guard cover without attachment
WARNING! Risk of injury due
to loss of control. Remove the at-
tachment (19) of the guard cov-
er (6) to avoid bumping the work-
piece.
48
Notes
• In general, work with a low feed
rate. Exert only moderate pressure
on the work-piece.
• A working angle of 30° to 40°
achieves the best results for rough-
ing.
Grinding with a wire brush
Requirements
• Suitable grinding brush
• Guard cover (6)
Notes
• Wear safety goggles as wires could
come loose.
• Only use disc brushes that are no
thicker than the maximum permit-
ted thickness (≤16.5 mm). Wires
can hit the guard cover and break.
• Suitable for rough rust removal,
cleaning weld seams and removing
paint.
• Exert only moderate pressure on
the workpiece. Do not exert ex-
cessive strain on the wire brush by
pressing down too hard.
Inserting and removing the
battery
WARNING! Risk of injury due to
unintentional start-up. Only insert
the battery into the device once the
device is fully prepared for use.
NOTICE! Risk of damage! An incor-
rect battery can damage the device
and battery.
Inserting the battery
1. Push the battery (3) along the
guide into the battery holder (2).
You will hear the battery click into
place.
Removing the battery
1. Press and hold the battery release
(21) on the battery (3).