Charging The Battery; Operation; Working Instructions - Parkside Performance Ppwsfa 20-Li B3 Traduction Des Instructions D'origine

2. Charge the battery (3) when only
the red LED on the charge level in-
dicator (13) is illuminated.

Charging the battery

See also the charger instruction
manual.
Notes
• If warm, allow the battery to cool
before charging.
• Do not expose the battery to dir-
ect sunlight for long periods and
do not place it on a radiator (max.
50°C).
Procedure
1. If necessary, remove the battery
(3) from the cordless device.
2. Slide the battery (3) into the char-
ging slot (25) of the charger (24).
3. Plug the charger (24) into an power
outlet.
4. Once charging is complete, dis-
connect the charger (24) from the
mains supply.
5. Pull the battery (3) charging slot
out (25).
Control LEDs on the charger (24):
green red
lights up —
— lights up Battery is char-
— flashes
flashes flashes
Meaning
• Battery is fully
charged
• stand-by (No
battery inser-
ted)
ging
Battery is over-
heated
Battery is defect-
ive

Operation

Working instructions

• WARNING! Risk of injury! If pos-
sible, use clamps to hold the work-
piece in place. Never hold a small
workpiece in one hand and the
device in the other while using the
device.
• DANGER! Risk of injury! Ensure
that you have sufficient space in
which to work, and that you do not
endanger other people.
• Adjust the guard cover such that
any sparks or detached parts
cannot hit either the user or any
bystanders.
The guard cover must also be po-
sitioned such that the sparks can-
not ignite combustible parts, in-
cluding those in the surroundings.
• The power tool must not be used
with a cutting stand.
• Only switch on the device when
the attachment tool is not touching
the workpiece.
• Excessive pressure reduces the
performance of the power tool and
leads to faster wear of the attach-
ment tool.
• Always work in the counter-direc-
tion. This ensures that the device is
not pushed out of the cut through
lack of control.
The direction of rotation arrow (7)
symbolises the running direction of
the attachment tool.
• After a heavy load, let the device
idle for a few minutes to cool down
the attachment tool.
• Do not touch the attachment tool
until it has cooled down.
Trial run
Always carry out a trial run without
a load before carrying out your first
GB MT
47