Safety Information; Meaning Of The Safety Information; Pictograms And Symbols - Parkside Performance Ppwsfa 20-Li B3 Traduction Des Instructions D'origine

WARNING! The vibration and
noise emissions may deviate from
the specified values during actual
use of the power tool, depending on
how the power tool is being used. Try
to keep the exposure to vibrations
as low as possible. An example of a
measure to reduce vibration expos-
ure is limiting the working hours. All
parts of the operating cycle have to
be considered while doing so (for ex-
ample, times when the power tool
is switched off and times when it is
switched on but running without any
load).
WARNING! Grinding thin metal
sheet or other well vibrating struc-
tures with a large surface area can
result in increased noise exposure
and a much (up to 15 dB) higher over-
all noise emission than the specified
noise emission values. Use heavy
flexible damping mats or similar to
prevent sound radiation from such
workpieces. Take into account the in-
creased noise emission and wear ap-
propriate hearing protection.
X 20 V TEAM
The device is part of the
X 20 V TEAM series and can be
operated with batteries of the
X 20 V TEAM series. Batteries of
the X 20 V TEAM series may only
be charged using chargers of the
X 20 V TEAM series.
We recommend that you oper-
ate this appliance with the fol-
lowing batteries only: PAP 20 B1,
PAP 20 B3, Smart PAPS 204 A1,
Smart PAPS 208 A1
We recommend charging these bat-
teries with the following chargers:
PLG 20 A3, PLG 20 A4, PLG 20 C1,
PLG 20 C2, PLG 20 C3, PLG 201 A1,
PDSLG 20 A1, PDSLG 20 B1,
Smart PLGS 2012 A1
Rechargeable battery and charger
technical data: See separate manual.

Safety information

This section deals with the basic
safety instructions for using the
device.
WARNING! Injury and property
damage due to improper handling of
battery. Observe the safety informa-
tion and notes on charging and prop-
er use as shown in the instruction
manual for your battery and charger
from the series X 20 V TEAM. A de-
tailed description of the charging pro-
cess and further information can be
found in these separate operating in-
structions.
Meaning of the safety
information
DANGER! If you do not observe
this safety instruction, an accident will
occur. The result of which is severe
bodily injury or death.
WARNING! If you do not observe
this safety instruction, an accident
may occur. The result of which is
likely severe bodily injury or death.
CAUTION! If you do not observe
this safety instruction, an accident
will occur. The result of which is likely
minor or moderate bodily injury.
NOTICE! If you do not observe this
safety instruction, an accident will oc-
cur. The result of which is possible
damage to property.

Pictograms and symbols

Symbols used in the instruction
manual
Attention!
GB MT
35