Technical Data; Recommended Cutting Equipment - Husqvarna 414 EL Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Technical data

Electric motor
Type
Ampere
Lubrication system
Oil tank capacity, US pint/litre
Type of oil pump
Weight
Chain saw without bar or chain, empty tanks, lb/kg
Chain/bar
Recommended bar lengths, inch/cm
Usable cutting length, inches/cm
Drive sprocket type/teeth
Maximum chain speed, m/s

Recommended cutting equipment

Following is a list of recommended cutting equipment for Husqvarna electric chain saw model 414EL. This chain saw
model equipped with either of the listed guide bar and saw chain combination(s), fulfills the requirements according to
CAN/CSA-C22.2 No. 60745-1-07/UL 60745-1 and CAN/CSA-C22.2 No. 60745-2-13-11/UL 60745-2-13.
Kickback information
The guide bar nose radius is determined by either the maximum number of teeth in the nose sprocket or the
corresponding maximum nose radius of a solid bar.
As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our list.
For guide bars of the same length, all sprocket-nose guide bars of the same pitch and having the same number of
sprocket teeth may be considered to have equivalent kickback energy.
Warning! The vibration emission during actual use of the power tool can differ from the declared
!
total value depending on the ways in which the tool is used. Operators should identify safety
measures to protect themselves that are based on an estimation of exposure in the actual
conditions of use (taking account of all parts of the operating cycle such as the times when the
tool is switched off and when it is running idle in addition to the trigger).
28 – English
TECHNICAL DATA
414EL
Series AC Motor
14,5 AMPS
0.42/0,20
Automatic
10,4/4,7
16/40
14/35,5
Spur/6
14,5

Publicité

Table des Matières
loading

Table des Matières