Publicité
Les langues disponibles
Les langues disponibles
EN
9. Place the connecting cable in the gap above the upper guide rail (
10. Seal the gap above the upper guide rail(
page 8, 1) with suitable sealant.
7.3
Connecting the electrical power
The electrical installation and setup of the device must be performed by a qualified electrician who has
demonstrated skill and knowledge related to the construction and operation of electrical equipment and
installations, and who is familiar with the applicable regulations of the country in which the equipment is to
be installed and/or used, and has received safety training to identify and avoid the hazards involved.
All other actions are intended also for non-professional users.
If present, use a connection that is switched off when the motor is running.
Otherwise insert a lockout switch in the electrical circuit in order to ensure no current is transferred to the lighting
when the ignition is activated. This prevents the lighting from being switched on during travel.
The lockout switch can be executed via a break contact relay which is connected to the D+ signal (See
on page 9).
8
1
Fig.
on page 8, 2) and drill hole (
2
Fig.
on page 8, 2).
Fig.
on
Fig.
Publicité
