Descaling Procedure - Bialetti Smart CF65 Instructions D'emploi

DESCALING PROCEDURE

The normal use of the machine with natural mineral water, both in bottle
and from the tap, entails the formation of limescale.
It is recommended to carry out the descaling cycle every 300 cups of
coffee (otherwise every 3-4 months) and/or when a constant decrease
of the dispensed coffee fl ow is noticed.
THE FREQUENCY OF THIS OPERATION DEPENDS ON THE
HARDNESS OF WATER USED.
A) Pour a dose of Bialetti descaling solution or equivalent (provided it is
not toxic and is suitable for coffee machines) into the water tank (4).
DO NOT USE VINEGAR OR VINE-
GAR-BASED SOLUTIONS AS DESCAL-
ING AGENT.
Fill the tank with cold water up to the MAX level.
B)
Press the button (2) to switch the machine on. Wait until it remains
C)
steady on.
Be sure to use the machine without capsule inside: if needed, open
D)
and close the lever (1)
Dispense 2 cups of water (aprox.ly 150 ml each).
E)
Switch the machine off.
F)
Let the descaling agent act for aprox.ly 15-20 minutes with the
G)
machine off.
Switch the machine on and carry out again the operations described
H)
in point e).
Switch the machine off against for approx.ly 5 minutes.
I)
Repeat the operation described in points i) until the tank is completely
J)
empty.
Remove the tank and rinse it thoroughly with clean cold water.
K)
Fill the tank with clean water up to the "MAX" level and insert it in
L)
its seat.
Dispense water until the tank is completely empty. If necessary, start
M)
dispensing several times (the machine features a safety system,
which interrupts the dispensing automatically after 100 operating
seconds).
Repeat the steps described in points l) and m).
N)
7. Maintenance
EN
37