Publicité
Les langues disponibles
Les langues disponibles
Farm-Clean
Illustration 2
The distance between the lower side of the collector box and the sweeping surface (ground clearance) can be adjusted by
means of the turning handles. (see Illustration 3) After mounting the collector box, you must adjust this distance to +/- 20 mm
(see Illustration 3). Depending on the material to be swept, you can place the collector box a little higher if necessary.
Illustration 3
Illustration 4
To empty the collector box, follow this simple procedure: take hold of the handle of the collector box (the handle that points
towards the push bar) and pull towards you. The machine must be turned off when emptying the collector box.
If the machine is used without the collector box, the mounting supports must be removed. Failure to remove them could result in
accidents.
When adjusting the height of the collector box, you also have to adjust the height of the brushes. Always observe the clearance
of +/- 20 mm (measured from the surface to be swept till the lower side of the collector box).
5.6 Radial sweeping brush
The Tuchel FARM-CLEAN is also available with a hydraulic Radial sweeping brush. (90cm diameter) Ask your dealer for more
information.
Monitoring and Maintenance schedule
Name:____________________________________
Street + No.:__________________________________
Postal Code:___________________ City:___________________
County:____________________________
Telephone no.:___________________
Fax no.:______________________
E-Mail:_____________________________
Date of Purchase:_________________
Article: FARM-CLEAN, Honda GCV 160
Serialnumber:___________________
Yearly maintenance is obliged until 2 years after date of purchase. Otherwise, the Warranty will
be revoked.
Performed maintenance:
Date:
Autograph:
Stamp:
Tuchel Maschinenbau GmbH
29
Publicité
