Fitting The Harness; Balancing The Machine - Stihl Fsa 90 R Notice D'emploi

Fitting the Harness

The type and style of the
harness/shoulder strap depend on the
market.
The use of the shoulder strap/harness is
described in the chapter on "Approved
Combinations of Cutting Attachment,
Deflector, Handle and Harness".
Use Type AR batteries only with the
harness provided – do not combine with
other carrying straps (e.g. shoulder
strap, full harness, etc.).
FSA 90 R
All manuals and user guides at all-guides.com
Shoulder Strap
Put on the shoulder strap (1).
N
Adjust the length of the strap so that
N
the carabiner (2) is about a hand's
width below your right hip.
Balance the machine – see
N

"Balancing the Machine".

Balancing the Machine
The type and style of the harness and
carabiner (spring hook) depend on the
1
market.
Attaching Machine to Harness
2
Attach the carabiner (1) to the
N
carrying ring (2) on the shaft.
Floating Position
The cutting attachment should just
N
touch the ground.
The correct floating position is obtained
as follows:
English
2
1
1
2
19