Programming The Memories (Canticus Ii Only); Programming The Registers For The Tutti; Programming The Registers For The Crescendo Steps - Viscount Canticus I Mode D'emploi

Viscount CANTICUS I - II
2. PROGRAMMING THE MEMORIES

2.1 PROGRAMMING THE REGISTERS FOR THE TUTTI

To set the registers which will be activated by the TUTTI, first of all activate the function by pressing the button above the
first manual, then modify the configuration of the registers as you prefer. To save the new setting, keep the S (set) button
pressed and press the HR button.
2.2 PROGRAMMING THE REGISTERS FOR THE CRESCENDO STEP
These register settings are pre-set by the manufacturer company to its own taste, but can be modified by the user following
this programming procedure:
- Choose the step through the "CRESCENDO" pedal. The step you have selected will be displayed on the LED meter
located on the right panel.
- Add or switch off the required registers.
- Save this new configuration by pressing the S (SET) button, and press the HR button relating to the general memories
section.
Make sure that the TUTTI register is not on; otherwise, the new configuration will not be saved as a new Crescendo step,
but will be saved as the register configuration for the TUTTI.
2.2 MEMORIES PROGRAMMING
Press the cancel button marked C, then select the registers on the required section. Press the SET (S) button on the left under
the first manual, and keep it pressed while pressing one of the 6 dedicated memory buttons to select the memory where this
combination of registers is to be saved.
The contents of the general and dedicated memories can be saved on disk and reloaded as required: see chapter 6 for further
informations.
38