Connections On The Rear Panel - Viscount Canticus I Mode D'emploi

1.7 CONNECTIONS ON THE REAR PANEL

1
1
1. EXT +12V DC 300mA: A voltage of +12 Volts DC can be obtained from these two connectors. They are normally used
as a REMOTE function, for remote switch-on (with the EXT. SPK. switch under the manuals) of the optimal speakers
connected to the MAIN or ANTIPHONAL sections.
2. Main Out: Up to six speakers can be connected to this section, subdivided as follows:
- GT/I: Pair of stereo panorama outputs relating to the first manual.
- SW/II: Pair of stereo panorama outputs relating to the second manual.
- PEDAL: Pair of stereo panorama outputs relating to the pedal keyboard.
3. Antiphonal Out: Up to four speakers can be connected to this section, subdivided as follows:
- GENERAL 1 (+2): General Output. When used alone, this output will provide the overall sound of the organ
(monophonic). When used in combination with connector 3, it will emit the sound relating to the pedal section.
- 2: For use in combination with output 1 to obtain the same situation but in stereophonic panorama.
- 3 (+4): Monophonic output providing the sound of the first and second manuals.
- 4: For use in combination with output 3 to obtain the same situation but in stereophonic panorama.
N.B.: For a good sound result, we suggest you use the a.m. outputs as follows:
•
With only one box: output 1(+2)
•
With two boxes: outputs 1(+2) and 3(+4)
•
With four boxes: 1(+2), 2, 3(+4) and 4
4. INPUT: Pair of stereophonic panorama inputs for connection of external equipment which is to use the organ's
amplification system. In case of monophonic source, use the L (+R) input only.
Viscount CANTICUS I - II
2
3
37
2 2
4