Connections On The Rear Panel - Viscount Prestige 100 Guide Rapide

Viscount Prestige 100

2.6 CONNECTIONS ON THE REAR PANEL

1
1. [EXT. +12V DC] connectors: these sockets can be used to obtain the +12V DC voltage needed
to supply the VISCOUNT speakers connected to the [MAIN OUT] sockets and/or the
[ANTIPHONAL OUT].
2. [MAIN OUT] Section: this section contains eight line outputs, that can be activated by the
[MAIN ON] stop on the centre panel (point 2 of par. 2.2), to which a maximum of eight speakers
can be connected for external organ amplification.
By means of the internal set up functions, which can be called up using the central control unit,
it will also be possible to edit various parameters for these audio outputs (individual volumes,
delays and equalisations) and to set these outputs in such a way as to simulate the wind chests
of the original church organs. These functions called EXTERNAL OUTPUTS CONTROL and
EXTERNAL VOICES ROUTER are described in the "Advanced Manual".
WARNING!
- Pay particular attention to the fact that a non connected [MAIN OUT] socket also disables
the next ones. This means that if socket [6] is not connected, sockets [7] and [8] will not
work either.
- In order to reach a proper pipes simulation, you have to locate the speakers boxes according
to the output numbers. The speaker box connected to output [1] has to be located on the
extreme left followed by all other speakers connected to outputs [2], [3] and [4] sothat
the last speaker box connected to output [8] will be located to the extreme right.
3. [ANTIPHONAL OUT] section: This section contains four line outputs that can be activated
by the [ANTIPHONAL ON] stop on the centre panel (point 2 of par. 2.2). The signals are
divided among the four outputs according to the settings in the SET-UP menu (ANTIPHONAL
OUTPUTS SETTING function), of the internal amplification (VOICES ADJUST function)
and the distribution of the individual voice on the external outputs (EXTERNAL VOICES
ROUTER function). All these functions are fully described in the "Advanced Manual".
- Quick Guide
3
Internal connections by qualified service person only.
2
4
38