Central Control Unit - Viscount Prestige 100 Guide Rapide

The drawer located under the keyshelf contains the central control unit for all the internal functions
of the Prestige 100.
This "Quick Guide" describes the basic functions of this system, for a detailed description of all the
remaining functions and parameters please see the "Advanced Manual".
1
2
3
4
1. Display: 40-characters display on two lines showing all the pages relating to the organ's
functions.
2. Menu selection buttons: these buttons are used to select the four main display function menus,
as follows:
o [VOICES] (described in the "Advanced Manual"): menu of the main functions relating to
the organ voices.
o [SET-UP] (chap. 4): general functions for organ settings.
o [MIDI & UTILITY] (described in the "Advanced Manual"): settings for MIDI interface
and the rear outputs.
o [DISK] (described in the "Advanced Manual"): functions relating to floppy disks and the
files saved in them.
3. MIDI TO section: this section contains the buttons used to activate transmission of the MIDI
note codes on channels A and B of each manual and the pedal board. The LED for each button
shows the transmission status on the relative MIDI channel according to the rule:
o LED on: transmission of note codes enabled:
o LED off: transmission of note codes disabled:
For further information about the organ's MIDI interface capabilities, see the "Advanced
Manual".

3. CENTRAL CONTROL UNIT

A MAN. III B VOICES VALUE
SET - UP
A MAN. II B
A MAN. I B MIDI & UTILITY
A PEDAL B DISK PLAY
MIDI TO MENU
PEDAL MAN. I MAN. II MAN. III
VOLUMES
Quick Guide - Viscount Prestige 100
CURSOR ENTER
EXIT
RECORD METRONOME START - STOP
SEQUENCER
ORCH. REVERB GENERAL
41
6
5