Beurer pearl OT 80 Mode D'emploi page 23

After usage
1 Place the hormone strip on a non-absorbent surface We
recommend the blank side of the foil packaging of the hor-
mone strip as a surface; it can then be disposed of You
can use the timer in the app to measure the evaluation time
2 Wait for the test strips to develop for at least 10-15 minutes
but no longer than 20 minutes Preferably do not take the
measurement after 30min
3 After 30 minutes any change in your result should be dis-
regarded
Step 3
Take a visual reading with the App
:
1 After the test has been developed, select the strip on the
inputs menu of the App
2 Take a picture of the test strip: center the test strip in the
rectangle shown in the app Make sure the strip is well lit
and no shadows cast on in
3 Align the colored part (example for blue strip) of the test strip
with the colored part in the app, or let the automatic strip
detection pre-fi nd it for you; you can pinch, drag, and rotate
to make sure the strip is captured correctly
4 Align the test lines by dragging the handles on the side
up and down, so that the control and test lines of the test
strips are exactly covered by the rectangular layout shown
in the app When the lines are faint try to center them as
much as possible
Control line
Test line
23
or