Handling Electrical Cables; Target Group; Intended Use - Dometic Coolair Rtx1000 Instructions De Montage

CoolAir
2.2

Handling electrical cables

A
NOTICE!
Damage hazard
• Use cable ducts to lay cables through walls with sharp edges.
• Do not lay loose or bent cables next to electrically conductive materials
(metal).
• Do not pull on the cables.
• Attach and lay the cables in such a manner that they cannot be tripped over
or damaged.
• The electrical power supply may only be connected by a specialist work-
shop.
• The connection to the vehicle's electrical system should be protected as
follows:
– Power supply: RTX 24 V: 40 A; RTX 12 V: 80 A
– Voltage monitor: 2 A
• Never lay power supply lines (battery leads) in the vicinity of signal or control
cables.
3

Target group

The mechanical and electrical installation and setup of the device has demon-
strated skill and knowledge related to the construction and operation of auto-
motive equipment and installations, and who is familiar with the applicable
regulations of the country in which the equipment is to be installed and/or
used, and has received safety training to identify and avoid the hazards
involved.
4

Intended use

The parking cooler is used to supply the interior of the driver cab with cool and
dehumidified air.
The parking cooler is designed for stationary use. It can be used while driving.
The parking cooler is not suitable for installation in construction machines, agri-
cultural machines or similar equipment. They will not work properly if exposed to
strong vibrations.
The parking cooler must not be installed in or instead of roof hatches that are
intended or declared as emergency exits.
This product is only suitable for the intended purpose and application in accor-
dance with these instructions.
EN
Target group
5