Setting The Speed; Setting The Torque Cut-Off - BDS Maschinen MAB 1300 Mode D'emploi

Setting the speed

Setting the torque cut-off

MAB 1300
In addition to the mechanical gearbox, the machine is also equip-
ped with full-wave control electronics for stepless variable speed
adjustment.
First set the appropriate gear stage, then adapt the speed
‹
using the electronic speed control (31).
Gear stage
Stage 1
Stage 2
Stage 3
Stage 4
NOTE
► If possible, always select a setting with low gear stage and
high motor speed. The motor is then set with a higher torque
and therefore protected against overheating under heavy
load.
In order to protect the tool, the maximum torque of the machine
can be set using the controller (32).
The machine switches off when it reaches the maximum set tor-
que. After switching off, the machine must be switched off and on
again using the ON/OFF switch (21).
CAUTION
► Do not use this function to switch off the machine when
cutting threads in pocket holes.
Speed range
30 - 80 min
-1
50 - 120 min
-1
130 - 350 min
-1
210 - 550 min
-1
Operation
57