Removing The Drill Chuck - BDS Maschinen MAB 1300 Mode D'emploi

Using the drill chuck
MAB 1300
NOTE
► When using tools with drill chuck, the tool holder with retainer
must be dismantled.
For further information, see the section Dismantling/as-
sembling the tool holder.
Inserting the drill chuck
Insert the drill chuck onto the tapered mandrel and insert
‹
the combination into the morse taper (5) of the machine. If
necessary, use an adapter sleeve.
Open the drill chuck and insert the tool into the drill chuck.
‹
Close the drill chuck by hand and then tighten the drill chuck
‹
with the chuck key.

Removing the drill chuck

Unlock the drill chuck with the chuck key and remove the
‹
tool.
WARNING
Risk of injury!
► Tighten the drill chuck only with the chuck key provided.
► Always remove the chuck key from the drill chuck after tigh-
tening or loosening.
Preparation
53