BDS Maschinen MAB 1300 Mode D'emploi page 51

Weldon industrial tool holder
MAB 1300
NOTE
► When using tools with Weldon shank, the tool holder with
retainer must be assembled (delivery condition).
For further information, see the section Dismantling/as-
sembling the tool holder.
Inserting the tool
Before inserting, clean the Weldon shank of the tool and the
‹
tool holder.
Loosen both Allen screws in the tool holder with the Allen key
‹
(H) supplied.
Insert the tool into the tool holder.
‹
NOTE
► Use the ZAP 200 (A) reducing ring for tools with 19mm
Weldon shank.
► Insert the appropriate ejector pin (B,C,D,E) before inserting
a core drill.
Tighten both Allen screws in the tool holder using the Allen
‹
key (H) supplied.
Removing the tool
Loosen both Allen screws in the tool holder using the Allen
‹
key (H) supplied and remove the tool by pulling it down-
wards.
Remove the ZAP 200 reducing ring (A), if necessary.
‹
Preparation
51