Installation And Connection - Oase BioCompact 25 Notice D'emploi

‐ EN ‐
BioCompact 50
How to proceed:
 B
1. Remove the lid of the filter container.
2. Pull out the foam holder.
3. Pull out the filter box.
4. Fill the empty chamber of the filter box with
filter medium.
Push the suction cups into the mounting
5.
holes of the filter container with a twisting
movement.
6. Reassemble the unit in the reverse order.
7. Adjust the flow at the flow regulator.
– To reduce the flow: Move the flow
regula‐tor in the direction Min.
– To increase the flow: Move the flow
regu‐lator in the direction Max.
8. Fit the water distributor.
12
INSTALLATION AND CONNECTION
N O T E
Ensure that the pump never runs dry!
Possible consequences: The pump will be
destroyed.
Protective measure: Regularly check the
water level in the aquarium.
 C

Fasten the device, e.g. to the wall of the
aquarium.

Route the power connection cable such that
it forms a drip loop!

Switching on: Connect the unit to the mains.
The unit switches on immediately.

Switching off: Disconnect the unit from the
mains.
BioCompact 25/50