Basic Operation; Dab + Operation - LENCO PDR-035 Manuel D'utilisation

BASIC OPERATION

Press and hold the STANDBY button to turn on the unit. To turn off, press and hold the
DAB +/FM/Bluetooth/AUX
When the unit is turned on, press the SOURCE button to toggle between DAB +, FM, Bluetooth and AUX mode.
Volume Control
Tune the rotary knob to change the volume.
Adjusting the Antenna
The telescopic antenna at the rear panel of the unit should be fully extended to ensure a good DAB +/FM reception. Alter the
antenna position for the best reception.

DAB + OPERATION

The first time the DAB + mode is selected, it will automatically scan for available DAB + stations. Wait until the scanning has finished.
The display will show the scanning progress.
Full Scan
1. Press and hold the INFO/MENU button to access the menu control.
2. Rotate the ENTER knob (or press the
3. Then press the ENTER knob to start auto-scanning the available stations.
Manual Scan
1. Press and hold the INFO/MENU button to access the menu control.
2. Rotate the ENTER knob (or press the
3. Rotate the ENTER knob (or press the
4. Press the ENTER knob to confirm.
5. To select another channel (example 5A - 13F), press the
6. To quit the menu control, press the BACK button repeatedly.
Tuning
After scanning all the available DAB stations, press the
ENTER knob to tune to the station within a few seconds.
Storing DAB + Presets
You can save up to 20 DAB + stations.
1. Tune to the station you wish to store.
2. To save it to the preset channel 1 or 2 or 3, press and hold the numeric button respectively. Then it will save to that preset
channel.
3. To save it to other preset channel from 4 to 20, press and hold the numeric button "4". Preset channel list will be displayed.
4. Rotate the ENTER knob (or press the
5. Press the ENTER knob to save.
Recall Stored DAB + Presets
1. To recall the preset channel 1 or 2 or 3, press the numeric button respectively. Then it will tune to that preset channel.
2. To recall other preset channel from 4 to 20, press the numeric button "4". Preset channel list will be displayed.
3. Rotate the ENTER knob (or press the
4. Press the ENTER knob to recall.
Note:
- The telescopic antenna at the rear panel of the unit should be fully extended to ensure a good reception. Alter the antenna
position for the best reception.
Progress bar
or button) until the "Full Scan" is selected.
or button) until the "Manual Tune" is selected and then press the ENTER knob.
or button) to select the desired channel (5A - 13F).
or
or button) to select the desired preset channel to save.
or button) to select the desired preset channel to recall.
Number of stations found
or button and then press the ENTER knob to confirm.
button to display and navigate the station list. Then press the
6
STANDBY button again.