Crossover Frequency Setting; Lfe Attenuator Setting; Front Speaker Distance Setting; Center Speaker Distance Setting - Pioneer VSX-D414 Mode D'emploi

Setting up the receiver
• If you chose the small front speaker
setting, SW YES is automatically set and
locked.
• You can only select the PLUS setting if the
front speakers are set to L.

Crossover frequency setting

• Default setting: 100 Hz
Crossover frequency is the point where the
receiver divides the high and low sounds (the
frequencies) between the speakers. Since most
smaller speakers can't handle deep bass tones,
you can send these sounds to the subwoofer (or
if you don't have a subwoofer, the large (L)
speakers in your system) instead of the
speakers set to small (S) in your setup. Choose
the point at which you want the frequency
routed to the subwoofer (or L speakers).
We recommend setting this to 200 Hz if your S
speakers are smaller bookshelf-type speakers.
Use ' or ' to specify the crossover
•
frequency for your small speakers:
100 Hz
Sends bass frequencies below 100 Hz to the
subwoofer (or L speakers).
150 Hz
Sends bass frequencies below 150 Hz to the
subwoofer (or L speakers).
200 Hz
Sends bass frequencies below 200 Hz to the
subwoofer (or L speakers).
If all speakers (front, center, and surround)
are set to L, the crossover frequency can't be
set because there are no S speakers (
appears in the display).

LFE attenuator setting

• Default setting: 0 dB
Dolby Digital and DTS audio sources include
ultra-low bass tones. Set the LFE attenuator as
necessary to prevent the ultra-low bass tones
from distorting the sound from the speakers.
Use ' or ' to set the attenuation level
•
(0 dB, 10 dB or dB(
0 dB
∞
(displays
∞
When is selected (
display), LFE is not available.

Front speaker distance setting

• Default setting: 10 ft.
Sets the distance from the front speakers to the
listening position.
Use ' or ' to set the distance of the
•
front speakers from the main listening
position (within a range of 0.5 ft. to 45 ft.).

Center speaker distance setting

• Default setting: 10 ft.
The center speaker is normally placed directly
in the front of the listening room and closer to
the listening position than the front speakers.
This means that the sound from the center
speaker will be heard before the front speakers.
To prevent this, set the center speaker distance
setting to delay the sound from the center
speaker so that the sound from the front and
center speakers will be heard at the same time.
Use ' or ' to set the distance of the
•
center speaker from the main listening
position (within a range of 0.5 ft. to 45 ft.).
∞
)).
10 dB
)
appears in the
06
33
En