Making Recordings; Making An Audio Or A Video Recording - Pioneer VSX-D414 Mode D'emploi

Making Recordings

Making an audio or a video
recording
You can make an audio or a video recording
from the built-in tuner, or from an audio or video
source connected to the receiver (such as a CD
player or TV) through the analog jacks. You will
need to connect a CD recorder, tape deck, MD,
VCR, or DVR deck to the CD-R/TAPE/MD or
DVR/VCR outputs on the receiver to do so (see
pages 13–14 for more on this).
• The receiver's volume, balance, tone (bass,
treble, loudness), and surround effects have
no effect on the recorded signal.
1 Select the source you want to record.
Use the INPUT SELECTOR buttons to do this.
2 Select the input signal (if necessary).
Press SIGNAL SELECT on the front panel to
select the input signal corresponding to the
source component (see page 29 for more on
this).
3 Prepare the source you want to record.
Tune to the radio station, load the CD, video,
DVD etc.
4 Prepare the recorder (connected to
either the CD-R/TAPE/MD or DVR/VCR
outputs).
Insert a blank tape, MD, video etc. into the
recording device and set the recording levels.
Refer to the instructions that came with the
recorder if you are unsure how to do this. Most
video recorders set the audio recording level
automatically—check the component's
instruction manual if you're unsure.
5 Start recording, then start playback of
the source component.
08
41
En