Hach POLYMETRON 8811 Manuel D'utilisation De Base page 22

For output 7 allocated to the temperature measurement
IOUT 7 -> °C
START: XXXX
Press ENTER.
IOUT 7 -> °C
END: XXXX
Press ENTER.
For output 8 allocated to the direct measurement
IOUT 8 -> YYY
START: XXXX
Press ENTER.
IOUT 8 -> YYY
END: XXXX
Press ENTER.
ALARM menu
DISPLAY
PROGRAMMING
ALARM
Press ENTER.
• For relay 1 to 6 allocated to the concentrations:
ALARM
ALARM X YYY
Press ENTER.
ALARM Relay X allocated to channel Y/Z is the measurement number in case there are
2 measurements/channel.
ALARM X -> CH. Y/Z
The value of Y from 1 to 6 and the value of Z from 1 to 2 are adjusted using the SCROLL UP/DOWN
keys. The SELECT key enables to adjust Z or Y.
Press ENTER.
ALARM X -> Y/Z Rising and falling alarm X allocated to the measurement Z of channel Y which enables to
choose the direction between HIGH and LOW
SWITCHING XXXX
XXXX = HIGH/LOW
Press ENTER.
22 English
Beginning of scale.
XXXX is between 0 and 9999
End of scale.
XXXX is between 0 and 9999
YYY: unit of the direct measure.
Beginning of scale.
XXXX is between 0 and 9999
YYY: unit of the direct measure.
End of scale.
XXXX is between 0 and 9999
DESCRIPTION
Alarm and threshold programming.
Alarm relay activated.
X: Number of the relay
YYY: YES/NO