English; Priority Instructions - Tractel ET Notice D'utilisation

Always concerned to improve the quality of its products, TRACTEL SOLUTIONS S.A.S reserves the right to modify
the specifications of the equipment described in this manual.
This manual outlines all necessary instructions for the safe and the correct operation of Charlet snatch blocks.
Before using and maintaining this Charlet snatch block, for maximum safety and efficiency, make sure these
instructions are read, understood and applied by trained users.
This manual should be made available to every operator. Extra copies of this manual will be supplied on request.
Technical data sheets #6054, 6061 – 6055- 6163 are also available.
Contact Tractel Solutions for any additional information.
▪ NEVER USE FOR PERSONNEL LIFTING
▪ Never use this snatch block for a load exceeding its Working Load Limit (WLL). Shock loading or specific
conditions must also be taken into account when determining the appropriate product.
▪ Charlet snatch blocks allow operations with a high safety level. Make sure that the people in charge meet
the safety requirements of these operations.
▪ TRACTEL SOLUTIONS SAS disclaims all responsibility for the consequences due to disassembly or
modification of the product without prior agreement, especially in case of original components replacement
by spare parts of other origin.
▪ Modification or welding on this product is strictly forbidden without prior agreement from Tractel Solutions.
▪ For lifting applications, make sure the local applicable regulation is applied before using this product.
▪ Only use wire rope that corresponds to the snatch block characteristics.
▪ It is strictly forbidden to either stand or walk under the load.
▪ Never move the hanging load above or near people.
▪ Attach the block to a fixed anchoring point and ensure that it can support the snatch block WLL
▪ Warn the people around during the lifting or moving of the load.
▪ Never use a damaged pulley or if you have a doubt over its correct functioning.
▪ Never use the pulleys in aggressive atmospheres.
▪ When the snatch block is standing vertically on the floor, make sure it cannot tip. If the work area is not
stable, then lay the snatch block on its lateral side plate.
▪ Always use the adapted individual protection equipment (gloves, safety boots, helmet, glasses...) during the
material handlings.
▪ Regularly examine the condition of the material (see below).
▪ Only TRACTEL SOLUTIONS SAS genuine spare parts should be used.
M 6062 M
rev 13 – 06/2021
GB

English

PRIORITY INSTRUCTIONS

Page 15/66
www.tractel.com