Scope Of Delivery; Accessories; Description Of The Product And Accessories; General Description - Wilo SiBoost-Smart-2 Helix V605 Notice De Montage Et De Mise En Service

English

5.3 Scope of delivery

• Pressure boosting system,
• Installation and operating instructions of the
pressure boosting system,
• Installation and operating instructions of the
pumps,
• Installation and operating instructions of the con-
trol device,
• Factory acceptance test certificate (in accordance
with 10204 3.1.B),
• Installation plan if applicable
• Electrical wiring diagram if applicable
• Installation and operating instructions of the fre-
quency converter if applicable
• Additional sheet with the factory setting of the
frequency converter if applicable
• Installation and operating instructions of the sig-
nal transmitter if applicable
• Spare parts list if applicable.

5.4 Accessories

Accessories must be ordered separately if needed.
The accessories included in the Wilo range include
the following:
• Open break tank (example Fig. 13a),
• 8l diaphragm pressure vessel retrofit kit (example
Fig. 5)
• Larger diaphragm pressure vessel (on the suction
side or discharge side)
• Safety valve
• Dry-running protection:
• Protection against low water level (WMS) (Fig.
6a and 6b) in inlet mode (at least 1.0 bar) (sup-
plied fitted to the pressure boosting system if
part of the order)
• Float switch
• Low-water warning electrodes with level relay
• Electrodes for tank operation (special accesso-
ries on request)
• Flexible connection lines (Fig. 10 - B),
• Expansion joints (Fig. 9 - B),
• Threaded flanges and caps (Fig. 9 and 10 – D),
• Sound-insulating casing (special accessory on
request).
34

6 Description of the product and accessories

6.1 General description

The Wilo -pressure boosting system type
Siboost-Smart is supplied ready for connection as
a compact unit with built-in controls. It consists of
2 to 4 non-self-priming multistage vertical high-
pressure centrifugal pumps which are supplied
completely piped to each other and mounted on a
common base frame. The only connections that
have to be made are for the inlet and pressure
pipes and the electrical mains supply. It may also
be necessary to install accessories ordered and
supplied separately.
The pressure boosting system with non-self-
priming pumps can be connected both indirectly
(Fig. 8 - system separated by a non-pressurised
water break tank) and directly (Fig. 7 - connection
without separation of the system) to the water
supply mains. Detailed instructions for the pump
type used can be found in the attached installa-
tion and operating instructions for the pump.
Observe the relevant, applicable regulations and
standards for using the potable water supply and/
or fire extinguishing supply. The system must be
operated and maintained in accordance with the
relevant instructions (in Germany according to
DIN 1988 (DVGW)) so that the security of the
water supply is permanently guaranteed and
neither the public water supply nor other con-
sumption installations are detrimentally
affected. The relevant instructions or standards
(see section 1.1) on connection and the type of
connection to the public water mains must be
observed; and supplemented by regulations of
water companies or the responsible fire protec-
tion authorities, as required. In addition, local
conditions (e.g. a supply pressure that is too high
or fluctuates sharply and which might require the
installation of a pressure relief valve) must also be
observed.
WILO SE 04/2013