Mount Charging Converter; Tools Required; Installation Instructions - Dometic PERFECTPOWER DCC1224-10 Instructions De Montage Et De Service

PerfectCharge
8

Mount charging converter

8.1

Tools required

For the electrical connection you will need the following tools:
• Crimping tool
• 4 flexible connection cables: + and – for the starter battery, + and – for the body
battery. 1 flexible signal cable for connection to D+ or the ignition.
The required cross-section can be found in the table chapter "Connect charging
converter" on page 19.
• Cable lugs and conductor sleeves
For fastening the battery charger you will need the following tools:
• Machine bolts (M4) with washers and self-locking nuts or
• self-tapping screws or wood screws.
8.2

Installation instructions

When selecting the installation location, pay attention to the following instructions:
• The battery charger can be installed horizontally as well as vertically.
• The battery charger must be installed in a place that is protected from moisture.
• The battery charger may not be installed in the presence of flammable materials.
• The battery charger may not be installed in a dusty environment.
• The place of installation must be well ventilated. A ventilation system must be
available for installations in small, enclosed spaces. The minimum clearance
around the battery charger must be at least 5 cm (fig. 2, page 4).
• The battery charger air inlet and air outlet must remain free.
• At ambient temperatures higher than 40 °C (ex. in engine or boiler rooms, direct
sunlight), the battery charger may switch off, although the power of the con-
nected loads is below the rated load (derating).
• The device must be installed on a level and sufficiently sturdy surface.
EN
Mount charging converter
17