Dometic PERFECTPOWER DCC1224-10 Instructions De Montage Et De Service page 10

General safety instructions
2.2 Safety when installing the product
D
DANGER!
• Never mount the product in areas where there is a risk of gas or dust
explosion.
!
CAUTION!
• Ensure a secure stand!
The product must be set up and fastened in such a way that it cannot
tip over or fall down.
A
NOTICE!
• Do not expose the product to any heat source (such as direct sunlight
or heating). Avoid additional heating of the product.
• Set up the product in a dry location where it is protected against
splashing water.
2.3 Safety when connecting the product electronically
D
DANGER! Danger of fatal electric shock!
• For installation on boats:
If electrical devices are incorrectly installed on boats, this can lead to
corrosion damage on the boat. Have the product installed by a quali-
fied (boat) electrician.
• If you are working on electrical systems, ensure that there is somebody
close at hand who can help you in emergencies.
!
WARNING!
• Make sure that the lead has a sufficient cross-section.
• Lay the cables so that they cannot be damaged by the doors or the
bonnet.
Crushed cables can lead to serious injury.
!
CAUTION!
• Lay the cables so that they cannot be tripped over or damaged.
A
NOTICE!
• Use ductwork or cable ducts if it is necessary to lay cables through
metal panels or other panels with sharp edges.
• Do not lay the AC cable and DC cable in the same conduit (empty
pipe).
10
PerfectCharge
EN