Haussmann 325596 Manuel D'utilisation page 18

OPERATING INSTRUCTIONS
b) To reconnect the spool to the trimmer,
insert the trimmer lines through the Brass
eyelets on the spool holder and pull the lines
out. Push the spool inwards against the
spring clip and then push the spool cover
firmly downwards until it locks in position (see
Fig 22 and 23).
Follow the instructions under the section
"Preparing the Trimmer for Use" to set the
nylon line to the correct length.
».
Fig 25
Fig 26
5) Installing Trimmer Line
a) Insert the replacement trimmer line
through the hole in the spool. Trimmer line
should be no longer than 10 feet (3 m) in
length (see Fig 24).
b) Snugly and evenly wind the trimmer line
onto the spool in the direction of the arrow
A
located on the spool (see Fig. 25).
c) Insert the trimmer line through the line
retaining slots located on the side of the
trimmer spool to hold the line in place (see
Fig 26). This trimmer uses 2 lines. Repeat the
18
Fig 24
procedure for both trimmer lines.
d) Lower the spool back onto the cutting head
and insert the trimmer line through the Brass
eyelets on the cutter head. With the line
through the eyelets, pull on the trimmer line
to release the line form the retaining slots and
seat the spool back onto the trimmer head.
Reinstall the spool head cover.
MAINTAIN TOOLS WITH CARE
Your power tool requires no additional
lubrication or maintenance. There are no user
serviceable parts in your power tool. Never
use water or chemical cleaners to clean
your power tool. Wipe clean with a dry cloth.
Always store your power tool in a dry place.
Keep the motor ventilation slots clean. Keep
all working controls free of dust. It is normal
to see some sparks flashing in the ventilation
slots, they will not damage your power tool.
Your trimmer line can dry out over time. To
keep your line in top condition, store spare
pre-wound spools or bulk line in a sealed
plastic bag.
Inspect tool cords periodically and if
damaged, have repaired by authorized
service facility.