Installation With Vehicle Lap Belt Only - Britax One4Life Clicktight Guide D'utilisation

9 Both red CLICKTIGHT release buttons are visible after installation.
9 All connections are secure and strap is not twisted.
9 Car seat base MUST be flat on vehicle seat and MUST be parallel to
vehicle seat.
9 Recline indicator is still within the correct section for FORWARD-facing,
after securing the child.
9 Child restraint cannot be moved front to back or side to side more than
2.5 cm (1 in.) at the belt path.
9 Excess top tether webbing is contained within your vehicle and secured.
9 The anti-rebound bar MUST be removed.
9 The lower infant insert and upper body support pillow must be removed.
NOTE: If the child restraint does not meet the above
criteria, repeat the installation steps or use a different
seating location in your vehicle.

Installation with Vehicle Lap Belt Only

1. Extend the top tether strap
by lifting on the top tether
adjuster.
2. Unhook the top tether hook
from the back of the child
restraint and place it up and
over the seatback.
3. Recline child restraint to the
appropriate position. Refer
to page 15 to determine
appropriate recline position.
4. Place child restraint
FORWARD-facing on the
vehicle seat so that the
car seat base is flat on the
vehicle seat and is parallel to
vehicle seat.
5. Ensure that no more than
7.5 cm (3 in) of the base
hangs over the front edge
of the vehicle seat.
6. Open the CLICKTIGHT.
Squeeze the CLICKTIGHT
release buttons underneath
the front cover flap and lift
to open.
30
7.5 cm