Publicité
Les langues disponibles
Les langues disponibles
Step 15:
Installation of cable 3 for butterfl y (29) with cable pulley
units.
1. Connect the both ends of cable 3 (29) with the appropriate
holder at butterfl y arm left and right (11+14).
2. Put two cable roller units as fi gure „A" shows together
with screw M10x45 (110), washer (118) and self locking nut
(124), insert the cable 3 (29) and connect them at cable pulley
holders 1 (8) in a way that the cable pulley can roll easy.
3. Put a cable roller unit as fi gure „A" shows together with
screw M10x45 (110), washer (118) and self locking nut (124),
insert the cable 3 (29) and connect this at twin cable pulley
holder (27) in a way that the cable pulley can roll easy.
Step 16:
Installation of cable 4 for leg curler (31) with cable pulley
units.
1. Pull cable 4 (31) through the big hole of leg curler (15) and
connect the end of cable 4 (31) at appropriate holder on
bottom side of leg curler holder (12) by using screw M10x25
(109), washer 10//20 (118) and self locking nut M10 (124) as
showed in fi gure „C".
2. Take cable 4 (31) and a cable pulley unit as showed in
fi gure „B" with screw M10x80 (114), washer 10//20 (118),
plastic bushing for pulley (95) and nut M10 (124). Insert the
cable pulley (83) with cable pulley cover (84) into the leg
curler (15) and position the plastic bushing (95) from outer
side of leg curler (15).
3. Put a cable roller unit as fi gure „A" shows together with
screw M10x45 (110), washer (118) and self locking nut (124),
insert the cable 4 (31) and connect this at cable pulley holder
1(8) in a way that the cable pulley can roll easy.
Step 17:
Installation of cable 2 (28) with cable pulley units.
1. Pull cable 2 (28) through the big hole of support 2 (7) and
connect the end of cable 2 (28) at cable pulley holder 2 (6)
by using screw M10x25 (109), washer 10//20 (118) and self
locking nut M10 (124) as showed in fi gure „B".
2. Put two cable roller unit as fi gure „A" shows together with
screw M10x45 (110), washer (118) and self locking nut (124),
insert the cable 2 (28) and install these units at holder of front
foot (1) in a way that the cable pulley can roll easy.
3. Put a cable roller unit as fi gure „A" shows together with
screw M10x45 (110), washer (118) and self locking nut (124),
insert the cable 2 (28) and connect this at twin cable pulley
holder (27) in a way that the cable pulley can roll easy.
4. Take cable 2 (28) and enlarge it with 8 links chain (53) and
two carbine hooks (55) and connect cable 2 (28) with cable
pulley holder 2 (6), which is pre-assembled at cable 1 (26).
(Note: To get a smooth sliding cable system, you may adjust
the cable system at 8 links chain (53) with carbine hooks (55)
through setting them into another position.)
25
Publicité
