Publicité
Les langues disponibles
Les langues disponibles
Assembly Instructions
Before beginning assembly, be sure to observe our re-
commendations and safety instructions. Some parts are
pre assembled.
Step 1:
Installation of front foot (1), rear foot (2) and guide bars
(10).
1. Put the front foot (1) and rear foot (2) on an even fl oor in
the right way together.
2. Put the guide bars (10) (ends with holes) into the
appropriate position of rear foot (2) and screw front foot (1),
rear foot (2) and guide bars (10) with screw M10 x 70 (112),
washer 10//20 (118) and self locking nut M10 (124) tightly.
Ensure that the screws are put through the holes of guide
bars so that they are blocked in bottom position.
Step 2:
Installation of weight plates (66+67) at guide bars (10).
1. Slide the weight supports (23) onto the guide bars (10).
2. Then put the rubber buffer (78) onto the guide bars (10).
(If you bought the option weight set Art.-No. 9388 you have
to put on the 2 weights of option set instead of the weight
supports, But fi rstly you have to slide onto the guide bars
(10) the rubber buffer (78)).
3. Place the 11 weights (67) onto the guide bars (10) as you
can see on step drawing 2.
4. Put the weight disc bar (40) into the weight plates (67) and
put at least the smaller fi rst weight (66) on.
5. To adjust the loaded weights use the weight selector
bar (51) and put it into the weight disc bar (40) in desired
position.
Step 3:
Installation of supports 1 + 2 ( 4+7) at front foot and rear
foot (1+2).
1. Put the support 1 (4) into the appropriate position of rear
foot (2) and tighten it fi rmly by using screw M10 x 70 (112),
washer 10//20 (118) and self locking nut M10 (124).
2. Put the support 2 (7) into appropriate position of front
foot (1) and tighten it fi rmly by using screws M10 x 70 (112),
washers 10//20 (118) and self locking nut M10 (124) .
20
Publicité
