Philips Saeco Spidem My Coffee Mode D'emploi page 13

ADJUSTMENTS - COFFEE BREWING
when the grinder is running.
The machine lets you make slight adjustments to the
coffee grinder to adapt it to the kind of coffee used.
This adjustment is carried out by adjusting the knob
found on the inside of the coffee bean hopper; this knob
must be pressed and turned only with the grinder ad-
justment key (20) provided with the coffee machine.
(Fig.28-29) - While the grinder is running, press and
turn the knob (with the supplied key) one notch at a
time and brew 2-3 cups of coffee; the grinder adjust-
ment may only be noticed in this way. The references
located inside the coffee bean hopper indicate the grind
setting.
1 - Coarse Grind
2 - Medium Grind
3 - Fine Grind
5.3 Stand-by
The machine is designed for energy saving.
After 60 minutes of inactivity, the machine turns off au-
tomatically.
To turn the machine on again, simply press the power
button (17); in this case the machine will go through the
rinse cycle only if the boiler is cold.
5.4 Adjusting the Brewed Coffee
The machine allows you to adjust the amount of brewed
coffee according to your tastes and/or the size of your
coffee cup(s).
Each time you press and release the brew button (14)
or (15) the machine brews a pre-programmed amount
of coffee, which is different for each button. This amount
may be re-programmed to your taste. Each button may
be individually programmed for a specifi c brew setting.
As an example, the following procedure describes the
programming of button (14), which is normally associ-
ated with espresso coffee.
• (Fig.10) - Place a cup beneath the dispensing
spout.
• (Fig.12) - Press and hold down the brew button (14).
A green icon appears on the display:
• (Fig.12) - When the amount of coffee in the cup
reaches the desired level, release the brew button
(14).
This button (14) is now programmed; each time it is
pressed and released, the machine will brew the same
amount of coffee just programmed.
5.5 Dispensing Spout Adjustment
(Fig.9) - The height of the dispensing spout (4) may be
adjusted to better fi t the dimensions of the cups that you
wish to use.
Manually move the dispensing spout up or down to ad-
just its height.
The recommended positions are:
(Fig.10) - for use with small cups;
(Fig.11) - for use with large cups.
5.6 Aroma Adjustment
The machine allows you to adjust the amount of coffee
to be ground for each cup.
When you press and release the aroma button (18)
three selections are available (mild, medium, and
strong). The system sets the aroma according to your
personal taste.
Selection can be made when the beans appear on the
display. Each time the aroma button (18) is pressed and
released, the aroma changes by one step. Selection
must be made prior to brewing coffee.
13