Maintenance And Cleaning - Beurer ELLE MPE 38 Mode D'emploi

Before you can begin using the UV nail dryer, you must insert the UV fluorescent tubes.
In order to do this, follow the steps below:
1. Remove the base plate.
3. Insert the base plate.
4. Operation
Drying UV nail gel
1. Insert the mains plug into the socket.
2. There are two different UV light exposure settings available (120-second timer and continuous operation).
3. To set the exposure time to 120 seconds, set the switch to Timer On. Then press the Start button. The UV
light will light up for 120 seconds. The UV light will automatically go off after 120 seconds. The majority of
commercially available UV nail gels have a curing time of 120 seconds. For more information, please ob-
serve the information from the corresponding nail gel manufacturer. After the 120 seconds, you can restart
the 120-second timer by pressing the Start button.
To set the exposure time to "Continuous operation", set the switch to
continuously. This mode is required for gels with a shorter or longer curing time than 120 seconds.
4. Insert your nails varnished with UV nail gel into the opening in the device (with your nails facing upwards).
5. Switch the device off once you have finished using it. For this purpose, set the switch to the centre position
and disconnect the device from the mains.

5. Maintenance and cleaning

Replacing the fluorescent tubes
If one of the four fluorescent tubes ceases to work properly, replace all four fluorescent tubes.
You can order the required fluorescent tubes from Customer Services.
Warning
Before replacing the fluorescent tubes, pull the mains plug out of the socket!
2. Carefully insert the fluorescent tubes into the
sockets.
Important
Ensure that the brass terminals are correctly
inserted.
9
. The UV light will light up