Publicité
Les langues disponibles
Les langues disponibles
EN
2. Specific Failure & Solution
Failure
The LED does not
come on when unit is
plugged in.
Some buttons can't
work, or the LED
display is not normal.
The Cooking Mode
Indicator comes on,
but heating does not
start.
Heating stops
suddenly during
operation and the
display flashes "u".
Heating zones of the
same side ( Such as
the first and the
second zone ) would
display "u" .
Fan motor sounds
abnormal.
The above are the judgment and inspection of common failures.
Please do not disassemble the unit by yourself to avoid any dangers and damages to the induction hob.
18
Problem
No power supplied.
The accessorial power
board and the display
board connected
failure.
The accessorial power
board is damaged.
The display board is
damaged.
The display board
is damaged.
High temperature
of the hob.
There is something
wrong with the fan.
The power board is
damaged.
Pan Type is wrong.
Pot diameter is too
small.
Cooker has over
heated;
The power board and
the display board
connected failure;
The display board of
communicate part is
damaged.
The Main board is
damaged.
The fan motor is
damaged.
Solution A
Check to see if plug is
secured tightly in outlet
and that outlet is working.
Check the connection.
Replace the accessorial
power board.
Replace the display
board.
Replace the display
board.
Ambient temperature
may be too high. Air
Intake or Air Vent may
be blocked.
Check whether the fan
runs smoothly；
if not , replace the fan.
Replace the power
board.
Use the proper pot
(refer to the instruction
manual.)
Unit is overheated. Wait
for temperature to return
to normal.
Push "ON/OFF" button to
restart unit.
Check the connection.
Replace the display
board.
Replace the power
board.
Replace the fan.
Solution B
Pan detection circuit is
damaged, replace the
power board.
Publicité
