Connections; Connection And Power Daisy Chain - dB Technologies VIO L1610 Manuel D'utilisation

Table des Matières

Les langues disponibles

English

4. CONNECTIONS

The figure above shows a general connection where a module 1

is over module 2. For this purpose, use cables with powerCON TRUE1® connectors (not provided).

•

Connect the power supply of module 1 AUTO-RANGE MAINS INPUT (A).

•

Link the power supply from module 1 to module 2 connecting the output MAINS LINK (B) of module

1 to the input AUTO-RANGE MAINS INPUT (C) of module 2.

•

Repeat this procedure until connecting the maximum permitted number of the line-array module

(refer to section SPECIFICATIONS).

WARNING

•

VIO-L1610

The cables must be properly sized and the system's design, installation and

testing should be performed by qualified personnel only. AEB industriale declines

any responsibility in case of cables that are non-compliant, uncertified and

incompatible with the proper layout of the system and the regulations in force

for the country of use.

MODULE 1

MODULO 2

Code 420120324 REV. 1.0

Table des Matières

Table des Matières