dB Technologies VIO L1610 Manuel D'utilisation page 53

English
• Fix the brakes on the DT-VIOL210 wheels.
• On the back, insert the movable arms into the brackets as shown in the
• Insert the pins corresponding to the previously calculated angles inside the arms (for this operation,
you do not need to lift the modules).
• Carry out audio, RDNet and power supply re-link connections as described in the previous paragraphs.
To find the maximum number of power connections in a re-linked system, see the
SPECIFICATIONS section.
• Remove the top cover and the tubes on the back of DT-VIOL210.
• Install the DRK-210 fly-bar on the upper module according to the settings checked with
DBTECHNOLOGIES COMPOSER.
• Lift the 4 modules anchored to DRK-210 using one or two engines and the appropriate means for
rigging (not provided).
• Disengage the brakes from the DT-VIOL210 wheels and put dolly back in the rest position.
WARNING
DRK-210 was designed for the suspension of up to 22
VIO L1610 for a maximum weight of 750 kg with a single
hooking point.
The VIO L1610 suspension components allow connecting up
to 9 modules (300 kg max) without limiting the angle of the
line array. Any other configuration or information regarding
the system's data, such as the maximum capacity and
hooking points, must be verified prior to the installation
using the software dBTechnologies Composer (refer to
the relevant paragraph in this manual). It is available for
free on the website www.dbtechnologies.com under the
DOWNLOADS section.
VIO-L1610
!
MECHANICS paragraph.
TECHNICAL
Code 420120324 REV. 1.0
53