dB Technologies VIO L1610 Manuel D'utilisation page 38

The example shows the case in which you want to set an angle of 3° between 2 modules.
Before carrying out any other work, once the movable arm [6] has been inserted, make sure that the hole of the
selected angle is inside the slot, as shown.
• FLOWN SCENARIO: insert only 1 pin in the hole corresponding to the angle chosen. The second pin can be
housed in the "PIN HOLDER" hole. Note that this type of configuration during installation allows changing
the selected angle by simply moving the relevant pin (with the movable arm inserted).
• STACKED SCENARIO: as soon as one pin [5] has been inserted in the hole of the chosen angle, lift module B
until the movable arm [6] allows it. Now insert the second pin into the "ANGLE LOCK" position and release
module B. In this way module B is completely blocked on the back thanks to the 2 pins.
Always make sure that all pins are fully inserted and locked at the end of assembly.
VIO-L1610
38
EXAMPLE: 3°
!
WARNING
English
Code 420120324 REV. 1.0