Features Of The Amplifier And Control Sections; Remote Control - dB Technologies VIO L1610 Manuel D'utilisation

FEATURES OF THE AMPLIFIER AND CONTROL SECTIONS

The class D digital amplifier is the heart of the VIO-L1610
modules.
It allows delivering up to 1600 W RMS, silently and efficiently
System is controlled by a powerful DSP allowing an immediate
and quick configuration of the line-array in any context of use.
Thanks to the possibility of a networking with RDNet, the
parameters on the panel can be remotely controlled through the
"AURORA NET" software (refer to

REMOTE CONTROL

paragraph).
The DIGIPRO G4 panel is made up of:
• Input, Output and Control Section
• Power Supply Unit Section
!
WARNING
• Do not obstruct the rear heat sinks of the
amplifier. If the module heats up excessively,
the audio volume is gradually reduced until
the module is thermally stabilized. The audio
is automatically restored when the normal
operating temperature is reached.
• Never attempt to disassemble the amplifier in
any way.
• In the event of a malfunction, remove power
supply immediately by disconnecting the
unit from the power mains and contact an
authorised repair centre.
• Preferably use cables with original, high quality
Neutrik® connectors. Periodically check their
integrity.
• The fuse installed at the factory is rated for
operation in the 220-240 V voltage range. If you
need to operate the speaker in the 100-120 V range:
1.
2.
3.
WARNING
• Never remove the front grille protecting the product.
To prevent the danger of electric shock, in case of accidental damage or replacement of the
protection grille (to be carried out at the service), disconnect power supply immediately.
Never connect mains power supply when the grille is removed.
VIO-L1610
40
DSP PRESET PARAMETERS AND
Disconnect all connections, including
the power supply connection.
Wait 5 minutes.
Replace the fuse with the fuse rated for
the 100-120 V range, which is included
in the package.
!
AEB INDUSTRIALE S.R.L.
Via Brodolini, 8 Località Crespellano
40053 VALSAMOGGIA (BO) - ITALY
"CAUTION"
RISK OF ELECTRICAL SHOCK
DO NOT OPEN
"ATTENTION"
RISQUE DE CHOCH ELECTRIQUE
NE PAS OUVRIR
MAINS FUSE
(REPLACE FUSE WITH SAME RATINGS)
(REMPLACER LE FUSIBLE AVEC LE MÊME TYPE)
220-240V~ (T5A L 250V~)
100-120V~ (T10A L 250V~)
MAINS LINK
220-240V~ (13,0Amax)
100-240V~ 50-60Hz
2990Wmax
220-240V~ 50-60Hz 3,0A 100-120V~ (15,1Amax)
100-120V~ 50-60Hz 4,9A 1660Wmax
Code 420120324 REV. 1.0
English
R R D D N N e e t t
Expansion Card
Remote
USB Data Service Preset Active
Active
Link
Data In
Data Out
Analog Balanced Audio
Input Output / Link
System Test High Pass DSP Preset
Status
Filter [Hz]
Push and hold to test
Limiter
Flat Service / User 1
Signal
100 70 A 8 2
G
Mute/Prot
95 75 B 7 3
F
Ready
90 4
80 E C 6
85 5
D
SPEAKERS HIGH FREQ
COUPLING COMPENSATION