Size Data [Mm]; Unit Installation - AERMEC FCWI 222V Manuel D'utilisation Et D'installation

SIZE DATA [mm]

A
A
FCWI222V - FCWI222VN
FCWI223V - FCWI223VN 880
FCWI22VL - FCWI22VLN
FCWI322V - FCWI322VN
FCWI323V - FCWI323VN 990
FCWI32VL - FCWI32VLN
FCWI422V - FCWI422VN
FCWI423V - FCWI423VN 1170 360
FCWI42VL - FCWI42VLN
FCWI522V - FCWI522VN
FCWI523V - FCWI523VN 1450 356
FCWI52VL - FCWI52VLN
FCWI
222V - 223V - 22VL
322V - 323V - 32VL
422V - 423V - 42VL
522V - 523V - 52VL

UNIT INSTALLATION

WARNING : Before carrying out any intervention, use the necessary
Personal Protective Equipment.
WARNING: check that the power supply is disconnected before
carrying out any procedures on the unit.
WARNING: the electrical wirings, the installation of fan coils
and their accessories must only be carried out by people with
the proper technical and professional qualifications for the
installation, conversion, expansion and maintenance of the
systems and able to check that it is working properly and safe.
In particular, the electrical wirings require checks relating to:
- Measurement of the electrical system insulation resistance;
- Continuity of the protection wires.
If the fan coil is working in cold continuous mode inside an
environment where the relative humidity is high, condensate might
form on the air delivery. This condensate might be deposited on
any objects underneath and on the floor. To avoid the formation of
condensate on the external structure of the device while the fan is
C
B C
298 205
305 210
FCWI 42
FCW 42
220
J
230
FCWI 52
FCW 52
J
A
mm 880
mm 990
mm 1170
mm 1451
FCWI 22
FCW 22
FCWI 32
FCW 32
J
B C D
298 190 90
305 191 91
360 139 210 115
365 149 200 114
working, the average water temperature must not be lower than
the operating limits shown in this manual (which depend on the
thermo-hygrometric conditions of the ambient air). These limits
refer to unit operating with fan at minimum speed.
In order to prevent air stratification in the room, and therefore to
achieve improved mixing, it is advisable not to supply the fan coil
with water at a temperature over 65°C. The use of water at high
temperatures could cause squeaking due to the different thermal
expansion levels of the elements (plastic and metal). This, however,
causes no damage to the unit unless the maximum operating
temperature is exceeded.
The essential indications to install the device correctly are given
here.
The installer's experience will be necessary however, to
perfect all the operations in accordance with the specific
requirements.
The FCWI fan coil must be installed in a position where the
J
E F G H
68 21 36 25
69 24 46 28
21 42 25
30 46 34
J
J
I J
40 Ø70
50 Ø70
46 Ø70
50 Ø70
39