iKarus ECOPiccoloV2 Notice De Montage page 18

Rotorhead Assembly
67474
Push the flybar # 67474 through the rotorhead, then
push on flybar control arm # 67368 and fix it with
67561
the M2x6 screws # 67561 so that the stabiliser rod
sits in the centre and the two control arms are level.
67368
Ensure that the stabiliser rod can be turned easily
but has as little longitudinal play as possible.
67582
Now push the flybar weights # 67475 onto the paddle rod. The further out the weights are, the slower the
system.We recommend placing the
weights on the fly bar about 1.5 cm
67561
from the inner edge of the flybar
68305
paddle. Now place the hiller paddle #
68240
68240 on the stabiliser rod # 67474
until is flush with the outside of the
fixing lug of the paddle, and screw it on.
Take care that the paddles are on the
same plane as each other and the link
levers. Carry out this adjustment very
67475
carefully; it is important for the flying
67582
properties. The rotorhead can now
hang in the ball joints. Put the
helicopter down and look at the hiller rod. If the same paddle is always leaning downwards, check once
again whether the distance is the same on both sides to the middle, and if necessary correct it. If an imbalan-
ce remains, stick some self adhesive tape onto the higher paddle so that they are equally balanced.
Clip the two linkages # 67367 into the slots in the link lever and onto the longer arms of the swashplate inner
ring. Here, too, the sharp edged side of the clip is pointing towards the ball.
67367
18