Locating A Track (Ams/Direct Access); Playing Tracks Repeatedly (Repeat Play) - Sony DTC-ZE700 Mode D'emploi

Playback Operations
Locating a Track (AMS*/Direct
Access)
You can locate the tracks in a number of ways, but only
after you have recorded start IDs on the tape (see pages
15 to 18). To use Direct Access, program numbers
must be recorded on the tape (see pages 15 and 18).
g TIMER START ID
REC OFF PLAY AUTO RENUMBER REHEARSAL WRITE ERASE
POWER
To locate
The beginning of the next
or succeeding tracks
(AMS)
The beginning of the
current track(AMS)
The beginning of
preceding tracks (AMS)
By specifying the
program number of a
track (Direct Access)
* AMS = Automatic Music Sensor.
z
If you enter the wrong program number during
Direct Access
If you haven't pressed the ( (or · on the deck)
button, press CLEAR on the remote, then enter the
correct number. If you have already pressed the ( (or
· on the deck) button, pressing the CLEAR button
will not erase the wrong program number. Stop the
deck and reenter the program number.
z
If the deck detects a blank section of 9 seconds or
more, or the end of the tape
The deck rewinds the tape automatically to its
beginning and stops (Auto Rewind).
z
You can make the deck start playing automatically
from the beginning of the tape after rewinding
Press · while holding down 0.
EN
14
REC LEVEL
INPUT REC MODE SBM
OPEN/CLOSE STANDARD ON 4
MODE ANALOG 48 kHz
3
§
OPTICAL 44.1 kHz
COAXIAL LONG
2
OFF
RESET
1
AMS REC MUTE
≠ ± 0 ) R 0
PHONES
MARGIN
RESET ·
p P r
REC
≠ / ± ·
Press
± as many times as you want
while playing. For example, to
locate the second track ahead,
press twice.
≠ once while playing
≠ as many times as you want
while playing. For example, to
locate the second track behind,
press three times.
1 Enter the program number of
the track with the number
buttons.
Z
2 Press ( (or · on the deck).
Z
Playing Tracks Repeatedly
(Repeat Play) Z
You can play a specific track or all the tracks on the
tape repeatedly.
L R
5
6
7
8
9
10
PHONE LEVEL
REPEAT
0 10
Playing all tracks repeatedly
Press REPEAT repeatedly while playing a track until
"REPEAT" appears in the display. The deck will then
play back all tracks until it detects the end of the last
track, which may be:
— a blank section of 9 seconds or more
— the end of the tape
When the deck detects either of the above, it rewinds
the tape to beginning and plays back all tracks again.
The deck repeats this cycle up to 5 times, then
automatically stops.
To stop playing all tracks repeatedly
Press REPEAT repeatedly until "REPEAT" disappears.
Note
Repeat Play of all tracks is canceled when you take out the
cassette.
Playing a track repeatedly
Press REPEAT repeatedly while playing the track that
you want until "REPEAT 1" appears in the display.
The deck will then play back the track until its end,
which may be:
—the next start ID
—a blank section of 9 seconds or more
—the end of the tape
When the deck detects any of the above, it rewinds the
tape and starts playing from the start ID of the same
track again. The deck repeats this cycle up to 5 times,
then automatically stops.
To stop playing a track repeatedly
Press REPEAT repeatedly until "REPEAT 1" disappears.
Note
Repeat Play of a single track is canceled when you take out
the cassette.
OPEN/
CLOSE
COUNTER
REPEAT MODE RESET
1 2 3
3-858-189-12(1)