Playback Operations; About The Display - Sony DTC-ZE700 Mode D'emploi

Playback Operations

For basic playback operations, see page 8.

About the Display

You can use the display to show the following types of
time information:
• absolute time
• playing time of the track
• remaining time on the tape
• tape running time
MODE
RESET
g TIMER START ID MARGIN
REC OFF PLAY AUTO RENUMBER REHEARSAL WRITE ERASE RESET
POWER
MODE RESET
Showing the absolute time, playing time of
the track, remaining time on the tape, and
tape running time.
Press MODE (or COUNTER MODE on the remote).
Each time you press the button, the displayed
information changes as follows.
Absolute time
ABS TIME
8 20
Press
Playing time of the track
PGM TIME
Press
Remaining time on the tape
REMAINING
1 00
h
In the case of premastered DAT, the
remaining time is to the end of the
recorded portion.
Press
Tape running time
5 19
Press
To reset the tape running time
Press RESET (or COUNTER RESET on the remote).
REC LEVEL L R
INPUT REC MODE SBM
5
OPEN/CLOSE STANDARD ON 4 6
ANALOG 48 kHz
3 7
§ OPTICAL 44.1 kHz
COAXIAL LONG
2 8
OFF
1 9
AMS REC MUTE
≠ ± 0 ) R 0 10
PHONES PHONE LEVEL
p · P r
REC
0 10
m s
√
3 15
m s
√
m
√
m s
Playback Operations
Notes
• When playing certain types of premastered tapes, "BB"
may appear momentarily in the display at the beginning
of the tape.
• The playing time of the track does not appear in the
following cases
— When you start playing from the middle of the track
— During rewinding
• In standard-play mode, the remaining time on the tape
appears about 16 seconds after you start playing.
• The displayed remaining time may vary somewhat from
the actual remaining time, depending on the tape.
If "EMPHASIS" appears in the display
The deck is playing an audio signal recorded with
emphasis (in the higher frequencies). The deck,
however, plays the signal while automatically
deemphasizing it (with attenuation proportional to the
degree of emphasis).
EN
13
3-858-189-12(1)