Hatco FSCD Série Manuel D'installation Et D'utilisation page 7

English
Side
Air Deflector
Components
6. Install the included 4" (102 mm) legs (two people are
required for this step).
a. Tape the rear glass doors together to prevent them from
opening while tipping.
b. Carefully tip the unit onto its side and rest it on top of
cardboard on a flat surface.
c. at each corner, thread a 4" (102 mm) leg into the bottom
of the unit. Hand-tighten until almost snug. Do not over-
tighten.
d. Return the unit to the upright position.
e. Remove the tape from the doors.
NOTE: The feet on the 4" (102 mm) legs are adjustable for
leveling the unit. Use a 9/16" (14 mm) open-end wrench
to make leveling adjustments once the unit is placed in
its final position.
Form No. FSCDm-1016
Perforated
Stainless Steel
Top Shelf
Glass Top Shelf
Vent Panel
Stone Base
4"
(102 mm)
Legs
Sign Holder
removed
7. Reinstall the stone base shelf.
for clarity.
Locating
Peg
8. Reinstall the front air deflector along the front edge of the
9. Install the side air deflectors.
Front
Air Deflector
10. Install the top shelf.
7
4" Leg
Shorten
Lengthen
Adjustable
Foot
Leg Installation
a. Remove all tape and protective packaging from the shelf.
b. align the two holes on the back edge of the shelf with
the locating pegs on the base.
c. Carefully lower the shelf into position.
base. Long slots on air deflector should face to the front.
• The side deflectors rest between two screw heads on
each side of the base, directly in front of the side air
vents. The flat edge of the deflector should be positioned
against the glass side panel.
• If the unit is configured with a glass top shelf, install the
vent panel along the front edge of the top shelf frame.
Then, install the glass shelf.
• If the unit is configured with a perforated stainless steel
top shelf, install the shelf directly into the top shelf frame.
Perforated stainless steel top shelves are designed to
allow proper air flow without the use of the vent panel.
INSTALLATION
Drain Valve
continued...