Important Safety Information - Hatco FSCD Série Manuel D'installation Et D'utilisation

English
Read the following important safety information before using this equipment to avoid serious
injury or death and to avoid damage to equipment or property.
WARNING
ELECTRIC SHOCK HAzARD:
• plug unit into a properly grounded electrical receptacle of
the correct voltage, size, and plug configuration. If plug
and receptacle do not match, contact a qualified electrician
to determine and install proper voltage and size electrical
receptacle.
• Turn OFF power switch, unplug power cord, and allow unit
to cool before performing any cleaning, adjustments, or
maintenance.
• DO NOT submerge or saturate with water. Unit is not
waterproof. Do not operate if unit has been submerged or
saturated with water.
• Unit is not weatherproof. Locate unit indoors where
ambient air temperature is a minimum of 70°F (21°C).
• This unit is not "jet-proof" construction. Do not use jet-
clean spray to clean this unit.
• Do not steam clean or use excessive water on unit.
• Do not overfill water reservoir. Overfilling can cause
electrical shock. Water reservoir is full when "LO H2O"
stops flashing on CABINET TEMpERATURE display. Stop
filling when "LO H2O" stops flashing on display.
• Turn power switch OFF and allow unit to cool before
draining water reservoir.
• Do not pull unit by power cord.
• Discontinue use if power cord is frayed or worn.
• Do not attempt to repair or replace a damaged power cord.
Cord must be replaced by Hatco, an Authorized Hatco
Service Agent, or a person with similar qualifications.
• This unit must be serviced by qualified personnel only.
Service by unqualified personnel may lead to electric
shock or burn.
• Use only Genuine Hatco Replacement parts when service
is required. Failure to use Genuine Hatco Replacement
parts will void all warranties and may subject operators of
the equipment to hazardous electrical voltage, resulting in
electrical shock or burn. Genuine Hatco Replacement parts
are specified to operate safely in the environments in
which they are used. Some aftermarket or generic
replacement parts do not have the characteristics that will
allow them to operate safely in Hatco equipment.
FIRE HAzARD:
• Locate unit a minimum of 1" (25 mm) from combustible
walls and materials. If safe distances are not maintained,
discoloration or combustion could occur.
• Do not place anything on top of unit.
Make sure food product has been heated to the proper food-
safe temperature before placing in unit. Failure to heat food
product properly may result in serious health risks. This unit
is for holding pre-heated food product only.
Hatco Corporation is not responsible for actual food product
serving temperature. It is the responsibility of the user to ensure
that food product is held and served at a safe temperature.
The light fixtures in this unit have safety shields covering the
light bulbs to meet National Sanitation Foundation (NSF)
standards. To avoid
contamination, always operate the unit with the safety shields
properly installed.
Form No. FSCDm-1016
personal injury and/or

IMpORTANT SAFETy INFORMATION

Make sure all operators have been instructed on the safe and
proper use of the unit.
This unit is not intended for use by children or persons with
reduced physical, sensory, or mental capabilities. Ensure
proper supervision of children and keep them away from the
unit.
This unit has no "user-serviceable" parts. If service is
required on this unit, contact an Authorized Hatco Service
Agent or contact the Hatco Service Department at
800-558-0607 or 414-671-6350.
BURN HAzARD: Some exterior surfaces on the unit will get
hot. Use caution when touching these areas.
Locate unit at proper counter height in an area that is
convenient for use. Location should be level to prevent unit or
its contents from falling accidentally and strong enough to
support the weight of the unit and contents.
The National Sanitation Foundation (NSF) requires that units
over 36" (914 mm) in width or weighing more than 80 lbs.
(36 kg) either be sealed to or raised above the installation
surface. 4" (102 mm) legs are included to allow for proper
cleaning access below unit.
Do not move or relocate the unit for cleaning. The unit is bulky
and heavy.
Transport unit in upright position only. Before moving or
tipping unit, secure all glass surfaces, doors, pan rails, and/or
skirts with tape; and drain water from humidified units. Failure
to do so may result in damage to unit or personal injury.
Make sure to clean and sanitize stone surface properly after
deep cleaning the surface using abrasives and before placing
food product on unit.
Use non-abrasive cleaners and cloths only. Abrasive cleaners
and cloths could scratch finish of unit, marring its appearance
and making it susceptible to soil accumulation.
Do not lay unit on the side with the control panel or on the front
of a curved glass unit. Damage to unit could occur.
Do not slide pans across glass surface, use rough-bottomed
pans, or drop anything on glass surface. Scratching or
breakage may occur. Damage to glass surface or breakage of
glass caused by misuse is not covered under warranty.
Use of distilled water in water reservoir of humidified units is
recommended to preserve life of electrical and mechanical
components. If non-distilled water is used, reservoir will
require periodic
MAINTENANCE section for cleaning procedure). Unit failure
due to lime or mineral deposits is not covered under warranty.
Do not use deionized water. Deionized water will shorten life
of water reservoir and heating elements.
food
Clean unit daily to avoid malfunctions and maintain
operation.
3
WARNING
CAUTION
NOTICE
cleaning and deliming (refer to
sanitary