Wall Mount Control Switch - Napoleon Riverside Serie Manuel D'installation Et D'utilisation

framing
EN
5.8

wall mount control switch

This appliance is supplied with a wall switch control:
1. Assemble the control switch (FIG. 1).
2. Attach the switch box finishing materials template to the assembled control switch (FIG 2.).
3. Install the control switch using the nailing tabs and the 20' (6m) wire provided. Note the tabs can be bent for
install if required (FIG 3.).
4. Remove the template after finishing materials have been installed (FIG 3.).
Switch Box Housing
Switch Box
Template
Switch Box Trim
Switch Plate
ON/OFF Switch
FIG. 1 FIG. 2
Wall Mount
Control Switch
Wires
FIG. 3
24
W415-10001315 / D-0 / 07.10.24