3.5.5 - Operation in "Ventilation" mode only
• When used in this mode the air conditioner does not perform any action with regard
to temperature and air humidity in the room.
• To activate this mode, press the B4 key on the remote control several times until
the display shows one of the three settable speeds (HI, ME, LO).
3.5.6 - Operation in "Comfort" mode only (Automatic)
• In this mode, the machine's temperature is automatically regulated according to
the room's temperature. The fan speed is also automatically regulated according
to the set temperature (except in dehumidification mode).
• To activate this mode, press the B4 key on the remote control several times until
the display shows the symbol "
.5.7 - Operation in "Heating" mode only
3
• Using this mode, the appliance heats the room.
This function is only available for the versions with heat pump (HP).
• To activate this mode, press the B4 key on the remote control several times until
the LED 1 lights up red and the display shows the set temperature.
• In this run mode, the required temperature and fan speed can be set. After three
minutes (maximum time) the compressor should start and the air conditioner starts
heating the room.
The air conditioner has to defrost its battery periodically.
During this operation the air conditioner does not heat the room,
though its internal parts remain on except for the room air fan.
when the outdoor temperature is very low, there may be a slight
delay for passage from the minimum to the medium or maximum
speed from when the command is sent to the machine with the
remote control.
Like delays might occur on activating the swinging function of the
mobile baffle.
After having turned off the unit, the internal fan runs seconds more.
Then it stops and both air flaps close.
3.5.8 - Checking airflow direction
• Press key B8 on the remote control to activate/deactivate the continuous oscillation
of the moving air outlet deflector (1).
".
>>>>>
EN - 35
UNICO NEXT-F R290