To Clear Programmed Commands - Sony RM-VL600T Mode D'emploi

Tips for programming the
System Control functions
The following information helps
you to programme a consecutive
operation steps.
About the order of operation
steps
Some of the components may not
accept consecutive remote control
signals. For example, some TVs
generally may not respond to the
next signal right after the Power-
on signal. So, a series of
commands such as TV Power-on
and input select may not work
properly.
In this case, insert other signals to
other components, such as in the
example below:
TV Power-ontVCR Power-ont
VCR playbacktTV input select
To clear programmed
commands
1
Press and while holding
SET, press and hold for
more than 3 seconds the
SYSTEM CONTROL button
you want to clear.
GB
31